Free preview mode
Enjoy the free questions and consider upgrading to gain full access!
300-101
Free trial
Verified
Question 51
Which statement about local policy routing is true?
- A: It is used to policy route packets that are generated by the device.
- B: It requires all packets to be packet switched.
- C: It is used to policy route packets that pass through the device.
- D: It requires all packets to be CEF switched.
- E: It supports IPv4 packets only.
- F: It requires an ip address or access list as the matching criteria.
Question 52
Which three configuration parameters can a DHCPV6 pool contain? (Choose three.)
- A: Domain search list
- B: Router IP
- C: Default gateway
- D: Prefix delegation
- E: DNS servers
- F: Subnet mask ADE
Question 53
Which type of access list allows granular session filtering for upper-level protocols?
- A: Content-based access lists
- B: Context-based access lists
- C: Reflexive access lists
- D: Extended access lists
Question 54
Which two options are requirements for EIGRP authentication? (Choose two.)
- A: A crypto map must be configured.
- B: The Authentication key must be configured under the interface running EIGRP.
- C: The authentication key must be configured within the EIGRP routing configuration.
- D: The authentication key IDs must match between two neighbors.
- E: A separate key chain must be configured.
- F: AN IPsec profile must be configured.
Question 55
Refer to the exhibit. A network engineer executes the show ipv6 ospf database command and is presented with the output that is shown.
Which flooding scope is referenced in the link-state type?
- A: Link-local
- B: Area
- C: As (OSPF domain)
- D: Reserved
Question 56
Which ospf area prevent LSA type 4, LSA type 5? (Choose two.)
- A: Not so stubby
- B: Total stubby
- C: Stubby area
- D: Totally Not-So-Stubby Area
Question 57
What following parameters for the EIGRP authentication need to match in order for EIGRP neighbors to establish a neighbor relationship?
- A: Autonomous System number.
- B: K-Values
- C: If authentication is used both: the key number, the password, and the date/time.
- D: The neighbors must be on common subnet (all IGPs follow this rule).
Question 58
Which the Valid range for BGP private ASNs?
- A: 64512-65535
- B: 62464-65024
- C: 64512-65024
- D: 62464-64511
Question 59
Using new backup router in spite of faulty one in ospf domain but relationship with neighbor in one interface only not working, what is the reason of this problem?
(Choose two)
- A: area Id match
- B: authentication mismatch
- C: process id of ospf not match
- D: ospf timers not match
- E: MTU mismatch
Question 60
Which two statements are true of the OSPF link-state routing protocol? (Choose two.)
- A: Using the Bellman-Ford algorithm, each OSPF router independently calculates its best paths to all destinations in the network.
- B: Using the DUAL algorithm, each OSPF router independently calculates its best paths to all destinations in the network.
- C: OSPF sends summaries of individual link-state entries every 30 minutes to ensure LSDB synchronization.
- D: OSPF sends triggered updates when a network change occurs.
- E: OSPF sends updates every 10 seconds.
- F: When a link changes state, the router that detected the change creates a link-state advertisement (LSA) and propagates it to all OSPF devices using the 224.0.0.6 multicast address. CD
Question 61
Which BGP option is required when load sharing over multiple equal-bandwidth parallel links from a single CE router to a single ISP router over eBGP? Select the best response.
- A: eBGP Multipath
- B: eBGP Multihop
- C: BGP Synchronization
- D: Public AS numbers
Question 62
During a recent OSPF election among three routers, RTA was elected the DR and RTB was elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place of the DR while RTC becomes the new BDR. What will happen when RTA comes back online?
- A: RTA will take the place of DR immediately upon establishing its adjacencies
- B: RTA will take the place of DR only if RTB fails.
- C: RTA will take the place of DR only if both RTB and RTC fail.
- D: A new election will take place establishing an all new DR and BDR based on configured priority levels and MAC addresses. C
Question 63
When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA? (Choose two.)
- A: IPv6 address for the host
- B: Lifetime of the prefix
- C: Prefixes for the link
- D: Keepalive timers
- E: Request for the local host IP address
- F: Any route advertisements it has received BC
Question 64
The following exhibit shows ipv6 route output. What would the metric be for a summary route that summarizes all three OSPFv3 routes displayed?
- A: 160
- B: 140
- C: 120
- D: 100
Question 65
The Dev-1 and Dev-3 routers are OSPF neighbors over the Ethernet 0/0 connection. Based on the show ip ospf neighbor output from the Dev-1 and Dev-3 routers, which statement is true? Select the best response.
- A: Dev-1 is the DR because it has a higher OSPF router priority.
- B: Dev-1 is the DR because it has a lower OSPF router ID.
- C: Dev-3 is the DR because it has a higher OSPF router priority.
- D: Dev-3 is the DR because it has a lower OSPF router ID.
- E: Both Dev-1 and Dev-3 are using the default OSPF router priority.
Question 66
Refer to the exhibit. Which three statements accurately describe the result of applying the exhibited route map? (Choose three.)
- A: The map prohibits the redistribution of all type 2 external OSPF routes with tag 6 set.
- B: The map prohibits the redistribution of all type 2 external OSPF routes.
- C: The map redistributes into EIGRP all routes that match the pfx prefix list and the five metric values 40000, 1000, 255, 1, and 1500.
- D: The map prohibits the redistribution of all external OSPF routes with tag 6 set.
- E: All routes that do no match clauses 10 and 20 of the route map are redistributed with their tags set to 8.
- F: The map permits the redistribution of all type 1 external OSPF routes.
Question 67
What is the difference between the IPv6 addresses ::/0 and ::/128? Choose the best response.
- A: ::/0 is the unspecified address, and ::/128 is the multicast address.
- B: ::/0 is the unicast address, and ::/128 is the anycast address.
- C: ::/0 is the unicast address, and ::/128 is the multicast address.
- D: ::/0 is the anycast address, and ::/128 is the multicast address.
- E: ::/0 is the default route, and ::/128 is the unspecified address.
- F: ::/0 is the anycast address, and ::/128 is the default address. E
Question 68
Scenario -
You have been asked to evaluate how EIGRP is functioning in a customer network. Access the device consoles to answer the questions.
Instructions -
- Enter IOS commands on the device to verify network operation and answer for multiple-choice questions.
- THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
- Click on the individual device icons or use the tab at the bottom of the screen to gain access to the console for each device.
- No console or enable passwords are required.
- To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.
- There are five multiple-choice questions with this task. Be sure to answer all five questions before selecting the Next button.
What percent of R1's interfaces bandwidth is EIGRP allowed to use?
- A: 10
- B: 20
- C: 30
- D: 40
Question 69
Refer to the exhibit.
EIGRP has been configured on all routers in the network. What additional configuration statement should be included on router R4 to advertise a default route to its neighbors?
- A: R4(config)# ip default-network 10.0.0.0
- B: R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
- C: R4(config)# ip route 10.0.0.0 255.0.0.0 10.1.1.1
- D: R4(config-router)# default-information originate A
Question 70
Scenario -
You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running-config command.
Instructions -
- Enter IOS commands on the device to verify network operation and answer for multiple-choice questions.
- THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
- Click on the icon or the lab at the bottom of the screen to gain access to the console for each device.
- No console or enable passwords are required.
- To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.
- There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button.
How old is the Type 4 LSA from Router 3 for area 1 on the router R5, based on the output you have examined?
- A: 1858
- B: 1601
- C: 600
- D: 1569
Question 71
What is the NHRP role in DMVPN? (Choose two.)
- A: Obtains the next-hop to be used for routing
- B: Routes the packet through the tunnel
- C: Identifies the PIM-SM RP used to route the packet
- D: Can authenticate VPN endpoints
- E: It requires each tunnel endpoint to have a unique network ID
Question 72
Which statement is true about an IPsec/GRE tunnel?
- A: The GRE tunnel source and destination addresses are specified within the IPsec transform set.
- B: An IPsec/GRE tunnel must use IPsec tunnel mode.
- C: GRE encapsulation occurs before the IPsec encryption process.
- D: Crypto map ACL is not needed to match which traffic will be protected.
Question 73
What are the four main steps in configuring a GRE tunnel over IPsec on Cisco routers? (Choose four.)
- A: Configure a physical interface or create a loopback interface to use as the tunnel endpoint.
- B: Create the GRE tunnel interfaces.
- C: Add the tunnel interfaces to the routing process so that it exchanges routing updates across that interface.
- D: Add the tunnel subnet to the routing process so that it exchanges routing updates across that interface.
- E: Add all subnets to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic.
- F: Add GRE traffic to the crypto access-list, so that IPsec encrypts the GRE tunnel traffic. ABDF
Question 74
Scenario -
You have been asked to evaluate an OSPF network setup in a test lab and to answer questions a customer has about its operation. The customer has disabled your access to the show running-config command.
Instructions -
- Enter IOS commands on the device to verify network operation and answer for multiple-choice questions.
- THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
- Click on the icon or the lab at the bottom of the screen to gain access to the console for each device.
- No console or enable passwords are required.
- To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.
- There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button.
Which of the following statements is true about the serial links that terminate in R3?
- A: The R1-R3 link needs the neighbor command for the adjacency to stay up
- B: The R2-R3 link OSPF timer values are 30, 120, 120
- C: The R1-R3 link OSPF timer values should be 10, 40, 40
- D: R3 is responsible for flooding LSUs to all the routers on the network
Question 75
Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
- A: The crypto isakmp configuration is not correct.
- B: The crypto map configuration is not correct.
- C: The interface tunnel configuration is not correct.
- D: The network 172.16.1.0 is not included in the OSPF process
Free preview mode
Enjoy the free questions and consider upgrading to gain full access!