Free preview mode
Enjoy the free questions and consider upgrading to gain full access!
200-105
Free trial
Verified
Question 26
Which statement about switch access ports is true?
- A: They drop packets with 802.1Q tags
- B: A VLAN must be assigned to an access port before it is created.
- C: They can receive traffic from more than one VLAN with no voice support.
- D: By default, they carry traffic for VLAN 10.
Question 27
Which command shows your active Telnet connections?
- A: show cdp neigbors
- B: show session
- C: show users
- D: show vty logins
Question 28
Refer to the exhibit. How should Switch1 and Switch2 be connected in order to allow full communication between all of the hosts?
A.
B.
C.
D.
E.
F.
Question 29
Which two states are the port states when RSTP has converged? (Choose two.)
- A: forwarding
- B: discarding
- C: listening
- D: disabled
- E: learning
Question 30
The company internetwork is subnetted using 29 bits. Which wildcard mask should be used to configure an extended access list to permit or deny access to an entire subnetwork?
- A: 255.255.255.224
- B: 255.255.255.248
- C: 0.0.0.224
- D: 0.0.0.8
- E: 0.0.0.7
- F: 0.0.0.3
Question 31
A router has been configured to provide the nine users on the branch office LAN with Internet access, as shown in the diagram. It is found that some of the users on the LAN cannot reach the Internet. Based on the topology and router output shown, which command should be issued on the router to correct the problem?
- A: Branch(config-if)# no shutdown
- B: Branch(config-if)# duplex full
- C: Branch(config-if)# no keepalive
- D: Branch(config-if)# ip address 192.168.10.30 255.255.255.240
- E: Branch(config-if)# bandwidth 100
- F: Branch(config-if)# encapsulation 802.3
Question 32
Identify the four valid IPv6 addresses. (Choose four.)
- A: ::
- B: ::192:168:0:1
- C: 2000::
- D: 2001:3452:4952:2837::
- E: 2002:c0a8:101::42
- F: 2003:dead:beef:4dad:23:46:bb:101 ABEF
Question 33
Which process is associated with spanning-tree convergence?
- A: determining the path cost
- B: electing designated ports
- C: learning the sender bridge ID
- D: assigning the port ID
Question 34
Which command is necessary to permit SSH or Telnet access to a Cisco switch that is otherwise configured for these vty line protocols?
- A: transport output all
- B: transport preferred all
- C: transport type all
- D: transport input all D
That’s the end of your free questions
You’ve reached the preview limit for 200-105Consider upgrading to gain full access!
Free preview mode
Enjoy the free questions and consider upgrading to gain full access!