NS0-184Preview

You are installing an AFF A700 system with two disk shelves using ADPv2. After setting up the cluster, you realize that one drive shelf was powered off and that the drives have not been assigned to any of the nodes.
In this scenario, which two resources will help you find a solution? (Choose two.)

Click the Exhibit button.

After installation of a new ONTAP cluster, you experience a problem. You successfully create a support case on the NetApp Support site. The customer asks you how to view the status of the case.
Referring to the exhibit, which two steps would allow the customer to accomplish this task? (Choose two.)

You are preparing to install a new 4-node ONTAP 9.8 cluster. You have a pair of new Broadcom BES-52348 cluster switches.

In this scenario, what are three requirements for the successful installation of the cluster switches? (Choose three.)

You have completed a NetApp ONTAP installation and the customer asks you how they can open a Pl case with NetApp Support.

In this scenario, what should you tell the customer?

You have a 4-node ONTAP 9.8 cluster with an AFF A400 HA pair, and you are adding a FAS8300 HA pair to the cluster. The FAS8300 controllers are not new and were decommissioned from another cluster. You are asked to enable hardware-level HA on the FAS8300 controllers.

In this scenario, which shell is used on the FAS8300 controllers to enable this feature?

You are preparing for an installation of a new 4-node cluster that uses Cisco Nexus 3232C switches.

Which two files should be downloaded and from where? (Choose two.)

You deployed a new 2-node AFF A400 cluster that is running ONTAP 9.8. You performed the basic Installation steps. The customer wants to use the cluster exclusively for NVMe over Fabric (NVMe-oF) connectivity with the hosts.

In this scenario, which two statements are true? (Choose two.)

Your customer asks you to describe the Storage Interconnect network function.

In this scenario, which statement is true?

You have completed the installation of a new eight-node NetApp AFF A800 cluster that uses Cisco 3232C cluster interconnect switches. You want to verify that the installation is correct and meets applicable standards by creating a report that is exportable and that you can upload to the installation job record.

In this scenario, which NetApp tool would you use to create this report?

Which statement is true about the cluster peer health show command?

During an ONTAP upgrade, the administrator notices that several FC LIFs are in an offline state.

In this scenario, what would cause this problem?

A customer wants to use Active Directory logins to enable their storage administrators to log into an ONTAP cluster.

In this scenario, which two actions would be needed? (Choose two.)

A customer wants to make sure that they are notified by e-mail when the ONTAP cluster sends an AutoSupport message due to a hardware or a software error.

Which two AutoSupport parameters should you set manually to satisfy this requirement? (Choose two.)

You are configuring networking for a new AFF A800 cluster that runs ONTAP 9.8 software. You notice that newly created interface groups and VLAN interfaces are placed into broadcast domains by the system.

In this scenario, what provides this function?

You are installing a new AFF A250 2-node cluster at a remote site for a customer. The customer asks how they can connect to perform remote power management operations on the cluster from their HQ.

In this scenario, which connection would you advise the customer to use?

Which three limits must you verify before you begin to expand an ONTAP cluster? (Choose three.)

Your customer has a defective FAS8300 controller serving FC LUNs.

In this scenario, which step is required after replacing the controller?

Click the Exhibit button.

Referring to the exhibit, which RCF would provide the correct port usage configuration?

You are creating a new HDD-based aggregate with disk sizes greater than 10 TB.

In this scenario, what is the NetApp default RAID type?

You have just installed an ONTAP 9.8 cluster and created an interface group on each controller. You have also created two VLANs on each interface group.

In this scenario, what is the minimum number of broadcast domains that will be created to use the tagged VLANs?

You want to monitor and manage storage system parameters such as temperature, voltage, current, and fan speeds over Ethernet.

In this scenario, which component is a system-independent resource in the storage system that helps you accomplish this task?

You are working with a customer on a new data center installation. You need to calculate the noise levels, power draw, and heat that the NetApp systems in this data center will produce.

In this scenario, which two tools would satisfy these requirements? (Choose two.)

You have a problem with the installation of a FAS500f 4-node cluster and want to find documentation with a step-by-step description of the installation procedure.

In this scenario, which NetApp website contains the required information?

You must install a new FAS500f system at a customer's site. You are preparing for the installation and realize that there is no console cable to connect to the controllers.

In this scenario, which type of cable do you need to complete the installation?