FCSS_NST_SE-7.4
Free trial
Verified
Question 1
Refer to the exhibit, which shows the port1 interface configuration on FortiGate and partial session information for ICMP traffic.
What happens to the session information if a routing change occurs that affects this session?
- A: Only the interface and gateway information for dev=7 will be removed.
- B: The session information will not change unless the current route has been removed from the routing table.
- C: The session will be flagged as dirty but no route lookups will be performed.
- D: Sessions involving port7 or port19 will not have their routing information flushed.
Question 2
Refer to the exhibit, which contains the partial configuration of an IPsec VPN configuration.
After reviewing the configuration, what can you conclude about the IPsec VPN Phase 1 setup?
- A: The VPN is configured using IKEv2.
- B: Dead Peer Detection is disabled.
- C: The VPN is configured with DHCP over IPsec.
- D: The tunnel is configured as a route-based VPN.
Question 3
Refer to the exhibit, which shows the output of diagnose sys session list.
If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary?
- A: The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.
- B: Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.
- C: The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.
- D: The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.
Question 4
Refer to the exhibit, which shows the partial output of a diagnose command.
Which two conclusions can you draw from the output shown in the exhibit? (Choose two.)
- A: FortiGate will drop the expected traffic if it does not arrive within 23 seconds.
- B: Clearing the master session has no impact on the expectation session.
- C: This is a pinhole session to allow traffic for a TCP protocol that dynamically assigns TCP ports.
- D: The session is checked against firewall policy ID 25.
Question 5
Consider the scenario where the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate.
Which action will FortiGate take when using the default settings for SSL certificate inspection?
- A: FortiGate uses the CN information from the Subject field in the server certificate.
- B: FortiGate uses the SNI from the user's web browser.
- C: FortiGate will establish a connection without SSL/TLS inspection.
- D: The web filter will automatically bypass SSL inspection for this connection.
Question 6
Refer to the exhibits.
An administrator is attempting to advertise the network configured on port3. However, FGT-A is not receiving the prefix.
Which two actions can the administrator take to fix this problem? (Choose two.)
- A: Modify the prefix using the network command from 172.16.0.0/16 to 172.16.54.0/24.
- B: Manually add the BGP route on FGT-A.
- C: Restart BGP using a soft reset to force both peers to exchange their complete BGP routing tables.
- D: Use the set network-import-check disable command.
Question 7
Refer to the exhibit, which shows a partial output of a real-time LDAP debug.
What two conclusions can you draw from the output? (Choose two.)
- A: The user was found in the LDAP tree, whose root is TAC.ottawa.fortinet.com.
- B: FortiOS performs a bind to the LDAP server using the user's credentials.
- C: FortiOS collects the user group information.
- D: FortiOS is performing the second step (Search Request) in the LDAP authentication process.
Question 8
During which phase of IKEv2 does the Diffie-Helman key exchange take place?
- A: IKE_Req_INIT
- B: Create_CHILD_SA
- C: IKE_Auth
- D: IKE_SA_INIT
Question 9
In the SAML negotiation process, which section does the Identity Provider (IdP) provide the SAML attributes utilized in the authentication process to the Service Provider (SP)?
- A: SP Login dump
- B: Authentication Response
- C: Authentication Request
- D: Assertion dump
Question 10
Refer to the exhibit, which shows the partial output of diagnose sys session stat.
Which statement about the output shown in the exhibit is correct?
- A: 27 sessions have expired but are still in the session table in case any out-of-order packets arrive.
- B: 15 sessions have been categorized as ephemeral.
- C: 113 sessions have been dropped because of memory page exhaustion.
- D: 562 TCP sessions have their proto_state set to 01 if there is no inspection.
Question 11
Refer to the exhibit, which shows the partial output of command diagnose debug rating.
In this exhibit, which FDS server will the FortiGate algorithm choose?
- A: 66.117.56.37
- B: 208.91.112.194
- C: 209.22.147.36
- D: 64.26.151.37
Question 12
Refer to the exhibit, which shows the modified output of the routing kernel.
Which statement is true?
- A: The egress interface associated with static route 8.8.8.8/32 is administratively up.
- B: The default static route through 10.200.1.254 is not in the forwarding information base.
- C: The default static route through port2 is in the forwarding information base.
- D: The BGP route to 10.0.4.0/24 is not in the forwarding information base.
Question 13
Refer to the exhibit, which shows the output of the command get router info ospf neighbor.
To what extent does FortiGate operate when looking at its OSPF neighbors? (Choose two.)
- A: The local FortiGate has at least one interface that participates in a broadcast network.
- B: The local FortiGate has at least one interface that participates in a point-to-point network.
- C: The local FortiGate is the DR.
- D: Neighbor 0.0.0.18 is the designated router (DR).
Question 14
FortiGate performs different actions when in conserve mode depending on the configured memory thresholds.
Which actions correlates to which thresholds? (Choose two.)
- A: FortiGate exits conserve mode when the system memory goes below the configured green threshold.
- B: FortiGate starts dropping all new sessions when the system memory reaches the configured red threshold.
- C: FortiGate enters conserve mode when the system memory reaches the configured extreme threshold.
- D: FortiGate starts taking the configured action for new sessions requiring content inspection when the system memory reaches the configured red threshold.
That’s the end of your free questions
You’ve reached the preview limit for FCSS_NST_SE-7.4Consider upgrading to gain full access!
Free preview mode
Enjoy the free questions and consider upgrading to gain full access!