Free preview mode
Enjoy the free questions and consider upgrading to gain full access!
350-401
Free trial
Verified
Question 201
In a Cisco SD-Access fabric, which control plane protocol is used for mapping and resolving endpoints?
- A: DHCP
- B: VXLAN
- C: SXP
- D: LISP
Question 202
Which new enhancement was implemented in Wi-Fi 6?
- A: Uplink and Downlink Orthogonal Frequency Division Multiple Access
- B: Channel bonding
- C: Wi-Fi Protected Access 3
- D: 4096 Quadrature Amplitude Modulation Mode
Question 203
Which device makes the decision for a wireless client to roam?
- A: wireless client
- B: wireless LAN controller
- C: access point
- D: WCS location server
Question 204
An engineer configures GigabitEthernet 0/1 for VRRP group 115. The router must assume the primary role when it has the highest priority in the group.
Which command set is required to complete this task?
interface GigabitEthernet0/1
ip address 10.10.10.2 255.255.255.0
vrrp 115 ip 10.10.10.1
vrrp 115 authentication 407441579
- A: Router(config if)# vrrp 115 track 1 decrement 100 Router(config-if)# vrrp 115 preempt
- B: Router(config-if)# vrrp 115 priority 100
- C: Router(config-if)# vrrp 115 track 1 decrement 10 Router(config-if)# vrrp 115 preempt
- D: Router(config-if)# standby 115 priority 100 Router(config-if)# standby 115 preempt
Question 205
How is MSDP used to interconnect multiple PIM-SM domains?
- A: MSDP allows a rendezvous point to dynamically discover active sources outside of its domain.
- B: MSDP SA request messages are used to request a list of active sources for a specific group.
- C: MSDP depends on BGP or multiprotocol BGP for interdomain operation.
- D: MSDP messages are used to advertise active sources in a domain.
Question 206
If the noise floor is -90 dBm and the wireless client is receiving a signal of גˆ’75 dBm, what is the SNR?
- A: 15
- B: 1.2
- C: גˆ’165
- D: .83
Question 207
Refer to the exhibit.
The EtherChannel between SW2 and SW3 is not operational. Which action resolves this issue?
- A: Configure the channel-group mode on SW3 Gi0/0 and Gi0/1 to active.
- B: Configure the mode on SW2 Gi0/0 to trunk.
- C: Configure the channel-group mode on SW2 Gi0/0 and Gi0/1 to on.
- D: Configure the mode on SW2 Gi0/1 to access.
Question 208
Refer to the exhibit.
Which action completes the configuration to achieve a dynamic continuous mapped NAT for all users?
- A: Reconfigure the pool to use the 192.168.1.0 address range.
- B: Configure a match-host type NAT pool.
- C: Increase the NAT pool size to support 254 usable addresses.
- D: Configure a one-to-one type NAT pool.
Question 209
How does EIGRP differ from OSPF?
- A: EIGRP is more prone to routing loops than OSPF.
- B: EIGRP uses more CPU and memory than OSPF.
- C: EIGRP has a full map of the topology, and OSPF only knows directly connected neighbors.
- D: EIGRP supports equal or unequal path cost, and OSPF supports only equal path cost.
Question 210
Which AP mode allows a supported AP to function like a WLAN client would, associating and identifying client connectivity issues?
- A: client mode
- B: SE-connect mode
- C: sensor mode
- D: sniffer mode
Question 211
A client device roams between wireless LAN controllers that are mobility peers. Both controllers have dynamic interfaces on the same client VLAN. Which type of roam is described?
- A: intra-VLAN
- B: inter-controller
- C: intra-controller
- D: inter-subnet
Question 212
What are two differences between the RIB and the FIB? (Choose two.)
- A: FIB is a database of routing prefixes, and the RIB is the information used to choose the egress interface for each packet.
- B: The FIB is derived from the data plane, and the RIB is derived from the FIB.
- C: The RIB is a database of routing prefixes, and the FIB is the information used to choose the egress interface for each packet.
- D: The RIB is derived from the control plane, and the FIB is derived from the RIB.
- E: The FIB is derived from the control plane, and the RIB is derived from the FIB.
Question 213
Which component does Cisco Threat Defense use to measure bandwidth, application performance, and utilization?
- A: TrustSec
- B: Advanced Malware Protection for Endpoints
- C: NetFlow
- D: Cisco Umbrella
That’s the end of your free questions
You’ve reached the preview limit for 350-401Consider upgrading to gain full access!
Free preview mode
Enjoy the free questions and consider upgrading to gain full access!