QuestionQ227

VerifiedImplement and manage virtual networking

You have an Azure subscription that contains a virtual network named VNet1. VNet1 includes four subnets named Gateway, Perimeter, NVA, and Production.

The NVA subnet contains two network virtual appliances (NVAs) that will inspect network traffic between the Perimeter subnet and the Production subnet.

You need to implement an Azure load balancer for the NVAs. The solution must meet the following requirements:

  • The NVAs must run in an active-active configuration that uses automatic failover.
  • The load balancer must balance traffic to two services on the Production subnet. The services use different IP addresses.

Which three actions should you perform? Each correct answer presents part of the solution.

NOTE: Each correct selection is worth one point.

Choose three
Explanation

HA ports load-balancing rules are available only on an internal Standard Load Balancer, so you deploy a standard load balancer (B); a basic load balancer (A) can't use them. Both NVAs go into one backend pool with a health probe: per-instance health probes give active-active (n-active) distribution and fast failover to the healthy appliance. To handle the two services that use different IP addresses, you configure two private frontend IP configurations, each selected by its own HA ports rule, and both rules target the same NVA backend pool (E). Microsoft's supported configuration for multiple HA ports rules requires a unique frontend IP address for each rule and Floating IP enabled on every rule (C). A nonfloating HA ports rule (D) doesn't allow any other load-balancing rule on the load balancer, and a second backend pool (F) isn't needed because both rules send traffic to the same NVAs.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!