About the Exam

Prepare for the H13-341 certification from Huawei with 60 practice questions, community discussion, and detailed explanations.

Exam Topics

  • WDM Principles10%
  • Transmission Network Products5%
  • NG WDM Equipment Networking and Applications5%
  • Optical- and Electrical-Layer Grooming Solutions of NG WDM Equipment10%
  • NG WDM Equipment Commissioning15%
  • MS-OTN Features10%
  • OTN Protocol10%
  • MS-OTN Protection Principles10%
  • NG WDM Equipment Routine Maintenance5%
  • NG WDM Alarm Signal Flow Analysis10%
  • NG WDM System Troubleshooting10%

How to Use This Practice Exam

  1. Browse — Read each question, select your answer, and reveal the explanation.
  2. Exam Mode — Simulate real exam conditions with a timed session and score report.
  3. Learn Mode — Spaced repetition schedules questions you struggle with for long-term retention.

Download the Full Exam PDF

Get every question and answer in a clean, printable PDF built for offline study. Purchase once, keep permanent access, and re-download the latest version anytime.

Last updated November 27, 2025 at 1:41 PM

Topic filter
Question status
Question sort
Questions per page

QuestionQ1

VerifiedWDM Principles

Dispersion compensation is unnecessary for 40 Gbit/s and 100 Gbit/s coherent systems because coherent boards have high dispersion tolerance. NG WDM products do not support hybrid transmission of non-coherent and coherent networks.

Explanation

Coherent 40 Gbit/s and 100 Gbit/s transmission uses digital signal processing to compensate chromatic dispersion, avoiding DCM-based networking in typical deployments. NG WDM can coexist with and carry non-coherent and coherent wavelengths in a hybrid network when the optical design accounts for their differing power and performance requirements; therefore, the claim that it does not support hybrid transmission is incorrect.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ2

VerifiedMS-OTN Features

ESC may also be used at OLA sites.

Explanation

ESC is not supported for use at OLA sites; therefore, the statement is false.

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ3

VerifiedWDM Principles

Which of these statements concerning the modulation technologies used by 40 Gbit/s and 100 Gbit/s coherent systems are correct?

Choose two
Explanation

A 40 Gbit/s coherent system uses ePDM-BPSK, whereas a 100 Gbit/s coherent system uses ePDM-QPSK. QPSK conveys twice as many bits per symbol as BPSK, enabling the higher bit rate.

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ4

VerifiedWDM Principles

In a WDM system, after transmission over a distance, the OSNR of the signals at the receiving end decreases to a certain extent. Which of the following is the primary cause?

Explanation

An erbium-doped fiber amplifier (EDFA) adds amplified spontaneous emission (ASE) noise to the optical signal. The added ASE noise reduces the optical signal-to-noise ratio, particularly as amplification is used across a transmission link.

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ5

VerifiedTransmission Network Products

Which of the following ROADM boards contain WSS optical modules?

Choose three
Explanation

WSM9 and WSD9 perform wavelength-selective multiplexing and demultiplexing with WSS optical modules. WSMD9 also contains a WSS module as part of its combined ROADM design, whereas RDU9 provides signal broadcast/splitting rather than wavelength-selective switching. Thus, three listed boards contain WSS modules, so the requirement to choose only two is factually inconsistent.

Community Discussion

No comments yet. Be the first to start the discussion!

That's the end of the preview

It's free

Every verified question is free for all users.
No strings attached.

Topics covered
WDM PrinciplesTransmission Network ProductsNG WDM Equipment Networking and ApplicationsOptical- and Electrical-Layer Grooming Solutions of NG WDM EquipmentNG WDM Equipment CommissioningMS-OTN FeaturesOTN ProtocolMS-OTN Protection PrinciplesNG WDM Equipment Routine MaintenanceNG WDM Alarm Signal Flow AnalysisNG WDM System Troubleshooting
Know a question that should be here? Contribute to this exam
Back home