QuestionQ30

VerifiedEthernet switching network construction

LACP dynamically establishes an Eth-Trunk between SW1 and SW2. SW1 and SW2 each have eight interfaces available for aggregation, but only four links must be active.

Which parameter should the administrator configure to determine the switch responsible for selecting the active links?

Explanation

LACP system priority elects the device that controls active-member selection for an Eth-Trunk; the peer follows that selection so both ends use the same active links. Numerically lower system-priority values have higher priority. LACP interface priority only determines which individual interfaces are preferred after the controlling device has been selected.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!