QuestionQ31

VerifiedEthernet switching network construction

The administrator uses the interface Eth-Trunk 1 command to create Eth-Trunk 1 on SW1 and SW2. After the network stabilizes, the administrator runs display interface brief on SW1 and finds that Eth-Trunk 1 is Down, its member interfaces are in a normal state, and SW1's configuration is correct. A possible cause is that the member interfaces on SW2 have not been added to Eth-Trunk 1.

Explanation

In dynamic LACP mode, member interfaces that cannot receive LACPDUs from a remote aggregated interface enter the Indep state. They may remain physically operational, but they are not Up members of the aggregation, so the local Eth-Trunk is Down. The directly connected peer interfaces must also be added to an Eth-Trunk for the two ends to communicate as an aggregate.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!