QuestionQ23

VerifiedConnectivity

You are assisting an onsite network technician with bringing up an HPE Aruba Networking 9004 gateway through ZTP for a branch office. The technician was instructed to connect any port for the ZTP process to begin.

Thirty minutes after the gateway was connected, new users began reporting that they could no longer access the internet. One affected user reported an IP address of 172.16.0.81; however, the branch office network is intended to use 10.231.81.0/24.

What should the technician do to resolve the issue and start the ZTP process correctly?

Explanation

For an Aruba 9004 gateway, G0/0/1 is reserved for One Touch Provisioning and is not a supported ZTP port. ZTP must use another interface connected to a WAN service that provides DHCP, routing, DNS, and internet access. Moving the cable to G0/0/0 removes the connection from the reserved port and permits ZTP to proceed.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!