QuestionQ55

VerifiedSR OS Control Plane Security

Question Image

Routers R1 through R4 run an IGP such that each router has the other routers’ system IP addresses in its routing table. Static routes must be configured on R1 and R2 so they can reach subnet 10.4.100.0/24. The network administrator chooses to use indirect static routes in both cases. Which of the following would NOT be a correct decision?

Explanation

An indirect static route resolves its indirect IP address through the dynamic routing protocol and forwards toward the resolved next hop. Using R3 as the indirect address on both R1 and R2 sends the traffic to R3; R3 has no route to 10.4.100.0/24, because the required static routes exist only on R1 and R2. The traffic therefore cannot reach the destination subnet. Nokia SR OS specifies that an indirect address is resolved through a dynamic routing protocol and is used as the next-hop address for the destination route.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!