NS0-194: NetApp Certified Support EngineerDemo

By Netapp · Question Mode

QuestionQ17

Introduction to Networking in Clustered Data ONTAP

After a network card was replaced in an ONTAP node, you observe the output shown in the exhibit.

Question Image

What is the issue?

  • A The interface group is configured in single mode.
  • B One physical port is not cabled.
  • C One physical interface is broken.
  • D One physical interface is mis-cabled.
Explanation

The LACP interface group is configured for multimode operation, and both physical ports show an active, healthy link. However, e0g operates at 10,000 Mbps while e0h operates at 1,000 Mbps, so e0h cannot participate in the aggregated link. This indicates that e0h is connected to an incorrect switch port or configuration.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!