QuestionQ81

VerifiedRouting

Refer to the exhibit.

Question Image

What must be configured on Edge-1 to establish valid BGP routing between agg-sw1 and agg-sw2, using BGP and the IP addresses shown above?

Explanation

Edge-1 uses eBGP neighbors 10.0.0.2 and 10.0.0.4 because they are the directly connected aggregation-switch addresses and both peers are in AS 65200. Activating both neighbors in the IPv4-unicast address family enables IPv4 prefix exchange. A loopback source, route-reflector-client setting, or default-route origination does not supply that required eBGP IPv4 neighbor activation.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!