QuestionQ74

VerifiedRouting

A customer has configured eBGP peering with local AS 65000 on two routers from a CX 6300 VSF stack, using the following switch ports:

[ports connecting to router – 1 10.10.10.2]

Question Image

[ports connecting to router – 2 ip 10.10.20.2]

Question Image

The LAGs connect to third-party Layer 2 switches that act as a transit network for the eBGP routers. To optimize potential BGP peering issues, the AOS-CX switch has these global settings configured:

Question Image

What must be done on the AOS-CX switch to enable bidirectional forwarding with the eBGP peers?

Explanation

Global BFD timer settings alone do not enable BFD for BGP peers. Each BGP neighbor must be configured with neighbor <IPv4-address> fall-over bfd in the BGP router configuration context, which registers that peer with BFD for rapid session-failure detection. The two peer addresses are 10.10.10.2 and 10.10.20.2.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!