QuestionQ34Verified/Managing and MonitoringCopy linkReport a problemAsk AstroTutorSave questionRefer to the output from a CX6100 switch: Which correct detail can be observed from the output above?AThe dBm values for Tx are too far away from 0, and the link is down.Bthe dBm values for Rx are within acceptable values, and the link is up.CThe dBm values for Rx are too low, indicating that the link is down.DThe dBm values for Tx are too high and affect Rx signals.Show AnswerAnswerExplanationAn Rx reading of -40.00 dBm is extremely low, and the reported Rx Power low alarm, Rx Power low warning, and Rx loss of signal indicate that the receiver is not detecting sufficient optical signal for the link to operate. Aruba’s transceiver diagnostics use these alarm and error indicators to report low receive power and loss of signal.Learn moreAruba AOS-CX 10.13 Fundamentals Guide — show interface transceiverShow comments0Show commentsCommunity DiscussionNo comments yet. Be the first to start the discussion!
Community Discussion