HPE Network Switching Associate (HPE6-A86)

By HP · Question Mode

QuestionQ35

3. Install, configure, set up, and validate wired network solutions.

A network is configured with two 2930F switches in the aggregation layer. Each 2930F switch has ten connections. Twenty 2530 access switches connect to both aggregation switches using 1Gb RJ45. You must replace the aggregation switches with CX 6200 models.

In this scenario, which configuration provides redundancy by using two ports on the access switches to the aggregation layer?

Explanation

A CX 6200 VSF stack operates as a single logical switch. Therefore, the two uplink ports on each 2530 can be configured as one LAG while physically terminating on separate CX 6200 stack members, providing link and aggregation-member redundancy. The 2530 switches are not members of the CX 6200 VSF stack.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!