HPE Network Switching Associate (HPE6-A86)

By HP · Question Mode

QuestionQ3

3. Install, configure, set up, and validate wired network solutions.

A new firewall serving as the default gateway is connected to a CX 6300 switch. The security administrator has asked you to configure the L3 switch without using a bridged port.

How can this be accomplished on an HPE Aruba Networking switch?

Explanation

A firewall uplink that must not be bridged requires a Layer 3 routed physical interface. On an AOS-CX 6300, routing makes the interface Layer 3 and permits an IPv4 address to be configured directly on it. no routing instead creates a Layer 2 interface, and vlan access applies to Layer 2 access interfaces.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!