Free preview mode
Enjoy the free questions and consider upgrading to gain full access!
350-601
Free trial
Verified
Question 51
Which component is disrupted when the Cisco Integrated Management Controller is upgraded on a Cisco UCS Series Server?
- A: SAN traffic
- B: Cisco UCS Manager
- C: KVM sessions
- D: data traffic
Question 52
Which two configuration settings are available in the Cisco UCS Firmware Auto Sync Server policy? (Choose two.)
- A: Immediate Action
- B: User Notification
- C: User Acknowledge
- D: Delayed Action
- E: No Action
Question 53
A Cisco Nexus 9000 Series Switch experiences a startup configuration corruption. The engineer must implement a procedure to recover the backup configuration file from the switch. Which command set must be used?
- A: 1. Clear the current configuration of the switch 2. Restart the device 3. Copy a previously saved configuration file to the running-configuration 4. Copy the running-configuration to the startup configuration
- B: 1. Clear the current configuration of the switch 2. Restart the device 3. Copy the running configuration to the startup configuration 4. Copy a previously saved configuration file to the running configuration
- C: 1. Copy the running-configuration to the startup configuration 2. Clear the current configuration of the switch 3. Restart the device 4. Copy a previously saved configuration file to the running configuration
- D: 1. Restart the device 2. Copy the running-configuration file to a remote server 3. Clear the current configuration of the switch 4. Copy the running configuration to the startup configuration
Question 54
An engineer configures the properties of a Cisco UCS Cisco Integrated Management Controller network adapter for a standalone Cisco C-Series Server. The
Failback Timeout in the vNIC was set to 600. When the failure occurs, the secondary interfaces must be used and then failback when the primary interface becomes available again. Which action must be taken to meet these requirements?
- A: Set default VLAN on the adapters.
- B: Increase CoS to 6.
- C: Enable Uplink Failover.
- D: Disable VNTAG mode.
Question 55
An engineer must perform a backup operation of the Cisco UCS system. The backup must be transferred to a secure location using UDP and must contain information about VLANs, VSANs, and other policies. Also, the operations team requires the backup file to be in a human-readable format. Which configuration set meets these requirements?
- A: Type: All configuration Protocol: FTP
- B: Type: Full state Protocol: SFTP
- C: Type: Logical configuration Protocol: TFTP
- D: Type: System configuration Protocol: SCP
Question 56
When deploying a Cisco HyperFlex edge with a pair of switches, what is the minimum number of interfaces in trunk mode required on each HX node?
- A: 1
- B: 2
- C: 4
- D: 6
Question 57
Refer to the exhibit.
A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server.
Which configuration must be added on the remote OTV AEDs site?
A.
B.
C.
D.
Question 58
What is a benefit of independent resource scaling in Cisco HyperFlex hybrid architecture?
- A: remote booting of converged servers
- B: flexible expansion of compute, caching, and capacity
- C: multivendor converged node hardware support
- D: support for compute nodes with third-party storage
Question 59
Which method must a network engineer use to upgrade the BIOS firmware or a Cisco UCS standalone C-Series rack-mount server?
- A: Use the U-ACPI Interface.
- B: Use the Cisco host upgrade utility.
- C: Use the Cisco hardware upgrade utility.
- D: Use the Cisco host firmware policy.
Question 60
An engineer must configure the order in which the server attempts to boot from available boot device types using Cisco Integrated Management Controller (Cisco
IMC). The engineer must change the boot order configuration during the setup and apply the new requirements multiple times. The requirement is to change the
Cisco IMC actual boot order so it is different from the configured boot order. Which setting accomplishes this goal?
- A: Enable the system to boot with the configured boot order.
- B: Set the boot configuration directly through BIOS.
- C: Apply UEFI Secure Boot for a nonsupported operating system.
- D: Configure the legacy and precision boot order to be mutually exclusive.
Question 61
In an FCoE environment, for which two sets of data must an interface that implements the PAUSE mechanism always provision sufficient ingress buffer? (Choose two.)
- A: frames that were sent with high credit
- B: frames that were sent on the link but not yet received
- C: frames that were processed and transmitted by the transmitter after the PAUSE frame left the sender
- D: frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender
- E: frames that were sent on the link and received
Question 62
What are two types of FC/FCoE oversubscription ratios? (Choose two.)
- A: switch processing power to end-node processing power
- B: port bandwidth to uplink bandwidth
- C: server storage to end-node count
- D: edge ISL bandwidth to core ISL bandwidth
- E: host bandwidth to storage bandwidth
Question 63
DRAG DROP -
Drag and drop the characteristics from the left onto the correct storage systems on the right.
Select and Place:
Question 64
Refer to the exhibit.
An engineer is implementing zoning on two Cisco MDS switches. After the implementation is finished, E Ports that connect the two Cisco MDS switches become isolated.
What is wrong with the implementation?
- A: Zones are local to the MDS switch and name service must be used to activate the connection between E Ports.
- B: Different zone set names must be configured on both MDS switches.
- C: Zones must have the same name on both MDS switches for the E Ports to function.
- D: E Ports on both MDS switches must be configured as F Ports for the zoning to function.
Question 65
An engineer is implementing FCoE.
Which aspect of DCBXP on a Cisco Nexus switch affects this implementation?
- A: It requires that LLDP transmit and LLDP receive are enabled on the FCoE interface.
- B: It uses the Cisco Fabric Services protocol to exchange parameters between two peer links.
- C: It provides the authentication of peers on the Cisco Nexus switch.
- D: It always is enabled on 10/100-Mbps native Ethernet ports.
Question 66
Which product includes prebuilt templates that are available to be used to customize fabric deployments?
- A: Cisco Tetration
- B: Cisco Data Center Network Manager
- C: Cisco ACI
- D: Cisco UCS Manager
Question 67
Which statement describes the MAC address that the FCoE Initialization Protocol chooses for use by an E-Node in an FCoE implementation?
- A: The FCoE Initialization Protocol uses a 24-bit FC-MAP and concatenates a 24-bit Fibre Channel ID to create a fabric-provided MAC address.
- B: The FCoE Initialization Protocol uses the burned-in MAC address of the converged network adapter for all FCoE operations.
- C: FCoE does not use a MAC address. The FCoE Initialization Protocol is used to acquire a Fibre Channel ID, and the address is used for all FCoE communications in the same way as Fibre Channel Protocol.
- D: The FCoE Initialization Protocol uses 01.00.0C as the first 24 bits of the MAC address and appends a 24-bit Fibre Channel ID to derive a full 48-bit FCoE MAC address.
Question 68
A customer has a requirement to deploy a cloud service and needs to have full control over the underlying OS, data and applications.
Which cloud model meets this requirement?
- A: MaaS
- B: PaaS
- C: SaaS
- D: IaaS
Question 69
Which statement describes monitoring Fibre Channel traffic on a Cisco UCS 6332 Fabric Interconnect?
- A: Fibre Channel traffic is monitored only on one vHBA per server.
- B: Fibre Channel traffic is capable to be monitored as it is encapsulated as FCoE.
- C: The monitoring of Fibre Channel traffic is limited to the default VSAN.
- D: The destination port for monitoring must be an unassigned Fibre Channel port.
Question 70
An engineer is implementing NPV mode on a Cisco MDS 9000 Series Switch.
Which action must be taken?
- A: NPIV must be enabled on the upstream switch.
- B: The FCNS database must be disabled in the fabric.
- C: A port channel must be configured to the upstream switch.
- D: All switches in the fabric must be Cisco MDS switches.
Question 71
Which two statements describe modifying Cisco UCS user accounts? (Choose two.)
- A: Disabling a user account maintains all of the data in the Cisco UCS Fabric Interconnect.
- B: The admin account is used only to log on by using SSH.
- C: The password of the user account must contain a minimum of 10 characters.
- D: Local user accounts override the same account on a remote authentication server, such as TACACS, RADIUS, or LDAP.
- E: The password of the user account expires in 30 days.
Question 72
An engineer must ensure fabric redundancy when implementing NPV mode on a Cisco MDS 9000 Series Switch.
Which action enables fabric redundancy?
- A: Use TE ports to connect to upstream switches.
- B: Add a port channel to upstream switches.
- C: Configure the NPV devices to use an external FLOGI database.
- D: Connect the NPV devices to multiple upstream switches.
Question 73
An engineer is converting a Cisco MDS switch to support NPIV mode.
What should be considered when implementing the solution?
- A: It requires mapping of external interface traffic.
- B: It must be enabled on VSAN 1 only.
- C: It must be enabled globally on all VSANs.
- D: It requires the FLOGI database to be disabled.
Question 74
DRAG DROP -
An engineer must recover configuration on a Cisco MDS 9000 Series switch from a previous version that was backed up to bootflash and then verify the restoration.
Drag and drop the commands on the left to the correct order on the right.
Select and Place:
Question 75
Refer to the exhibit.
What is the result of implementing this configuration?
- A: The Fibre Channel interface is configured for SPAN.
- B: The Fibre Channel interface is configured for source distribution.
- C: The Fibre Channel interface is configured for FSPF.
- D: The Fibre Channel interface is configured for synchronization distribution.
Free preview mode
Enjoy the free questions and consider upgrading to gain full access!