Free preview mode

Enjoy the free questions and consider upgrading to gain full access!

350-401Free trialFree trial

By cisco
Aug, 2025

Verified

25Q per page

Question 101

Which benefit is offered by a cloud infrastructure deployment but is lacking in an on-premises deployment?

  • A: virtualization
  • B: supported systems
  • C: storage capacity
  • D: efficient scalability
—

Question 102

Which reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?

  • A: mismatched OSPF link costs
  • B: mismatched OSPF network type
  • C: mismatched areas
  • D: mismatched MTU size
—

Question 103

When configuring WPA2 Enterprise on a WLAN, which additional security component configuration is required?

  • A: PKI server
  • B: NTP server
  • C: RADIUS server
  • D: TACACS server
—

Question 104

A customer has several small branches and wants to deploy a Wi-Fi solution with local management using CAPWAP.
Which deployment model meets this requirement?

  • A: local mode
  • B: autonomous
  • C: SD-Access wireless
  • D: Mobility Express
—

Question 105

Refer to the exhibit.

Image 1

The WLC administrator sees that the controller to which a roaming client associates has Mobility Role Anchor configured under Clients > Detail.
Which type of roaming is supported?

  • A: indirect
  • B: Layer 3 intercontroller
  • C: intracontroller
  • D: Layer 2 intercontroller
—

Question 106

DRAG DROP -
Drag and drop the characteristics from the left onto the correct routing protocol types on the right.
Select and Place:

Image 1
—

Question 107

Which feature is supported by EIGRP but is not supported by OSPF?

  • A: route filtering
  • B: unequal-cost load balancing
  • C: route summarization
  • D: equal-cost load balancing
—

Question 108

What is the correct EBGP path attribute list, ordered from most preferred to least preferred, that the BGP best-path algorithm uses?

  • A: local preference, weight, AS path, MED
  • B: weight, local preference, AS path, MED
  • C: weight, AS path, local preference, MED
  • D: local preference, weight, MED, AS path
—

Question 109

A local router shows an EBGP neighbor in the Active state.
Which statement is true about the local router?

  • A: The local router is attempting to open a TCP session with the neighboring router.
  • B: The local router is receiving prefixes from the neighboring router and adding them in RIB-IN.
  • C: The local router has active prefixes in the forwarding table from the neighboring router.
  • D: The local router has BGP passive mode configured for the neighboring router.
—

Question 110

Refer to the exhibit.

Image 1

SwitchC connects HR and Sales to the Core switch. However, business needs require that no traffic from the Finance VLAN traverse this switch.
Which command meets this requirement?

  • A: SwitchC(config)#vtp pruning vlan 110
  • B: SwitchC(config)#vtp pruning
  • C: SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan add 210,310
  • D: SwitchC(config)#interface port-channel 1 SwitchC(config-if)#switchport trunk allowed vlan remove 110
—

Question 111

Refer to the exhibit.

Image 1

An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as the exit point.
Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplishes this task?

  • A: R4(config-router)bgp default local-preference 200
  • B: R3(config-router)bgp default local-preference 200
  • C: R4(config-router)neighbor 10.2.2.2 weight 200
  • D: R3(config-router)neighbor 10.1.1.1 weight 200
—

Question 112

Which action is the vSmart controller responsible for in a Cisco SD-WAN deployment?

  • A: onboard WAN Edge nodes into the Cisco SD-WAN fabric
  • B: gather telemetry data from WAN Edge routers
  • C: distribute policies that govern data forwarding performed within the Cisco SD-WAN fabric
  • D: handle, maintain, and gather configuration and status for nodes within the Cisco SD-WAN fabric
—

Question 113

Which feature of EIGRP is not supported in OSPF?

  • A: load balancing of unequal-cost paths
  • B: load balance over four equal-cost paths
  • C: uses interface bandwidth to determine best path
  • D: per-packet load balancing over multiple paths
—

Question 114

Which NTP Stratum level is a server that is connected directly to an authoritative time source?

  • A: Stratum 0
  • B: Stratum 1
  • C: Stratum 14
  • D: Stratum 15
—

Question 115

Refer to the exhibit.

Image 1

An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log:
*Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state
Which command set resolves this error?

  • A: SW1(config-if)#interface Gi0/0 SW1(config-if)#no spanning-tree bpdufilter SW1(config-if)#shut SW1(config-if)#no shut
  • B: SW1(config-if)#interface Gi0/0 SW1(config-if)#no spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
  • C: SW1(config-if)#interface Gi0/0 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
  • D: SW1(config-if)#interface Gi0/1 SW1(config-if)#spanning-tree bpduguard enable SW1(config-if)#shut SW1(config-if)#no shut
—

Question 116

When a wireless client roams between two different wireless controllers, a network connectivity outage is experienced for a period of time.
Which configuration issue would cause this problem?

  • A: Not all of the controllers in the mobility group are using the same mobility group name.
  • B: Not all of the controllers within the mobility group are using the same virtual interface IP address.
  • C: All of the controllers within the mobility group are using the same virtual interface IP address.
  • D: All of the controllers in the mobility group are using the same mobility group name.
—

Question 117

What is the role of the RP in PIM sparse mode?

  • A: The RP maintains default aging timeouts for all multicast streams requested by the receivers.
  • B: The RP acts as a control-plane node only and does not receive or forward multicast packets.
  • C: The RP is the multicast router that is the root of the PIM-SM shared multicast distribution tree.
  • D: The RP responds to the PIM join messages with the source of a requested multicast group.
—

Question 118

Why is an AP joining a different WLC than the one specified through option 43?

  • A: The AP is joining a primed WLC
  • B: The APs broadcast traffic is unable to reach the WLC through Layer 2
  • C: The AP multicast traffic is unable to reach the WLC through Layer 3
  • D: The WLC is running a different software version
—

Question 119

Image 1

Company policy restricts VLAN 10 to be allowed only on SW1 and SW2. All other VLANs can be on all three switches. An administrator has noticed that VLAN 10 has propagated to SW3.
Which configuration corrects the issue?

  • A: SW1(config)#int gi1/1 SW1(config)#switchport trunk allowed vlan 1-9,11-4094
  • B: SW2(config)#int gi1/2 SW2(config)#switchport trunk allowed vlan 10
  • C: SW2(config)#int gi1/2 SW2(config)#switchport trunk allowed vlan 1-9,11-4094
  • D: SW1(config)#int gi1/1 SW1(config)#switchport trunk allowed vlan 10
—

Question 120

Which First Hop Redundancy Protocol should be used to meet a design requirement for more efficient default gateway bandwidth usage across multiple devices?

  • A: GLBP
  • B: LACP
  • C: HSRP
  • D: VRRP
—

Question 121

A client device roams between access points located on different floors in an atrium. The access points are joined to the same controller and configured in local mode. The access points are in different AP groups and have different IP addresses, but the client VLAN in the groups is the same.
Which type of roam occurs?

  • A: inter-controller
  • B: inter-subnet
  • C: intra-VLAN
  • D: intra-controller
—

Question 122

Which DHCP option helps lightweight APs find the IP address of a wireless LAN controller?

  • A: Option 43
  • B: Option 60
  • C: Option 67
  • D: Option 150
—

Question 123

Where is radio resource management performed in a Cisco SD-Access wireless solution?

  • A: DNA Center
  • B: control plane node
  • C: wireless controller
  • D: Cisco CMX
—

Question 124

Refer to the exhibit.

Image 1

A network engineer is configuring OSPF between router R1 and router R2. The engineer must ensure that a DR/BDR election does not occur on the Gigabit
Ethernet interfaces in area 0.
Which configuration set accomplishes this goal?

  • A: R1(config-if)interface Gi0/0 R1(config-if)ip ospf network point-to-point R2(config-if)interface Gi0/0 R2(config-if)ip ospf network point-to-point
  • B: R1(config-if)interface Gi0/0 R1(config-if)ip ospf network broadcast R2(config-if)interface Gi0/0 R2(config-if)ip ospf network broadcast
  • C: R1(config-if)interface Gi0/0 R1(config-if)ip ospf database-filter all out R2(config-if)interface Gi0/0 R2(config-if)ip ospf database-filter all out
  • D: R1(config-if)interface Gi0/0 R1(config-if)ip ospf priority 1 R2(config-if)interface Gi0/0 R2(config-if)ip ospf priority 1
—

Question 125

Refer to the exhibit.

Image 1

Which type of antenna does the radiation pattern represent?

  • A: multidirectional
  • B: directional patch
  • C: omnidirectional
  • D: Yagi
—
Page 5 of 43 • Questions 101-125 of 1063
←
34567
→

Free preview mode

Enjoy the free questions and consider upgrading to gain full access!