QuestionQ36

VerifiedConfiguration

An engineer needs to configure an ERSPAN passive interface on a Cisco Secure IPS by using the Cisco Secure Firewall Management Center. The following configurations have already been completed:

  • Configure the passive interface.
  • Configure the ERSPAN IP address.

Which two additional settings are required to finish the configuration?

Choose two
Explanation

An ERSPAN interface requires a Flow ID so the source and destination sessions can identify the ERSPAN traffic, and a Source IP address for that ERSPAN traffic. Cisco’s FMC configuration procedure lists these as the ERSPAN parameters separate from configuring the interface IPv4 address and mask.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!