QuestionQ64

VerifiedExternal Network Connectivity

An engineer configures an L3Out between BLeaf1 and Core1. A Cisco Nexus 9000 Series Switch operates in NX-OS mode, and the two devices must establish OSPF peering. The network devices are configured as follows:

  • BLeaf1 is configured with IP address 10.1.0.2/31 and router ID 0.0.0.2.
  • Core1 is configured with IP address 10.1.0.3/31 and router ID 0.0.0.1.
  • On Cisco ACI, the engineer enabled OSPF with the default OSPF settings.
  • The engineer configured OSPF on the NX-OS switch by using the ip router ospf ACI_peering area 1 command.

Which action brings the OSPF adjacency up?

Explanation

Cisco ACI’s default L3Out OSPF area is area 0, while Core1 is assigned to area 1. OSPF neighbors connected on the same link require matching area IDs, so configuring BLeaf1 in area 1 resolves the area mismatch and allows the adjacency to form.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!