QuestionQ19Verified/NetworkCopy linkReport a problemAsk AstroTutorSave question Refer to the exhibit. The HSRP instance on each switch displays as active. Which action resolves the problem?AConfigure the HSRP timers to be the same.BAllow VLAN 100 between the switches.CConfigure the IP address of N9K-B on the same subnet as N9K-A.DConfigure preempt on only one of the switches.Show AnswerAnswerExplanationHSRP peers exchange multicast hello packets over the shared Layer 2 VLAN. If VLAN 100 is not permitted between the switches, neither switch receives the other’s hello packets; each therefore regards itself as active and lists the standby router as unknown. Allowing VLAN 100 between the switches restores HSRP peer communication and permits the priority election to select one active router.Learn moreCisco: Troubleshoot HSRP Common IssuesCisco Nexus 9000 Series NX-OS Layer 3 Configuration Guide: HSRPShow comments2Show commentsCommunity DiscussionNo comments yet. Be the first to start the discussion!
Community Discussion