QuestionQ66

VerifiedLayer 2 VPNs

Question Image

Refer to the exhibit. OSPF is used as the underlay routing protocol in this ISP backbone network. A network engineer recently configured R1 with ip cef and mpls label range 1000 2000. Several days later, the engineer replaced a failed RP module on R1. After the replacement, one of the customer MPLS LSPs went down with the error message LSP-ERROR-Indication:No Label Resources. Which action must the engineer take to resolve the issue?

Explanation

An Ethernet-over-MPLS pseudowire must bind its attachment circuit to the customer VLAN. Associating the xconnect with VLAN 10 supplies the required VLAN-mode attachment-circuit mapping for the EoMPLS virtual circuit, enabling the pseudowire’s label binding. The LDP adjacency is already operational, as shown by its Open state; targeted LDP, OSPF redistribution, and an MPLS MTU change do not correct a missing VLAN attachment-circuit binding. Cisco documents that an xconnect binds an attachment circuit to an MPLS pseudowire and that EoMPLS VLAN services require VLAN-mode configuration.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!