300-510 SPRI: Implementing Cisco Service Provider Advanced Routing SolutionsDemo

By Cisco · Question Mode

QuestionQ194

Unicast Routing

Question Image

Refer to the exhibit. After creating dynamic neighbors for the specified range, the network administrator with employee ID 4698:80:283 cannot see all established BGP neighbors.

What is the issue?

  • A A list of neighbors belongs only to a defined ASN.
  • B The listen limit is smaller than the prefix defined in the listen range.
  • C The peer groups must also be activated inside the address family.
  • D The single activated neighbor cannot be within the listen range.
Explanation

Each listen-range peer group must be activated under the IPv4 unicast address family. Activating only the individually configured neighbor 172.16.1.1 does not activate dynamic neighbors associated with group172 and group192; the peer groups require neighbor group172 activate and neighbor group192 activate in that address family.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!