QuestionQ59

VerifiedNetwork Access

Question Image

Refer to the exhibit.

PC1 regularly sends 1800 Mbps of traffic to the server. A network engineer must configure the EtherChannel so that Port Channel 1 between SW1 and SW2 is disabled when the Ge0/0 and Ge0/1 interfaces on SW2 go down.

Which configuration must the engineer apply to the switch?

Explanation

On Cisco EtherChannels, port-channel min-links sets the minimum number of member interfaces that must be up and bundled for the port-channel to remain operational. Cisco documentation states that this feature can cause an LACP EtherChannel to become inactive when too few active member ports remain to satisfy the required minimum bandwidth. Setting the minimum to 2 matches the requirement: if Ge0/0 and Ge0/1 on SW2 fail, only one bundled link is left, so the port channel is brought down. lacp port-priority, lacp max-bundle, and lacp system-priority do not shut the EtherChannel based on a minimum active-link threshold.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!