156-91580: Check Point Certified Security Expert Update - R80

By Checkpoint · Browse Mode
About the Exam

This is the Check Point CCSE update exam based on the R80.10 CCSE certification course. It is intended for candidates who already held a CCSE certification, including expired certifications, and who needed to renew or move to CCSE R80. Passing demonstrates troubleshooting skills and the ability to maximize the performance of security networks.

Exam Topics

  • CCSE Update0%

How to Use This Practice Exam

  1. Browse — Read each question, select your answer, and reveal the explanation.
  2. Exam Mode — Simulate real exam conditions with a timed session and score report.
  3. Learn Mode — Spaced repetition schedules questions you struggle with for long-term retention.

Download the Full Exam PDF

Get every question and answer in a clean, printable PDF built for offline study. Purchase once, keep permanent access, and re-download the latest version anytime.

Get PDF
Learn More

Last updated July 18, 2026 at 12:57 AM

Topic filter
Retired questions
Question sort
Questions per page

QuestionQ1

CCSE Update

In R80.10, which policy manages the IPS Blade?

Explanation

The IPS Blade is part of Check Point Threat Prevention and is managed through the Threat Prevention policy.

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ2

CCSE Update

is defined as a method of:

Explanation

IP spoofing falsifies a packet’s source IP address so the packet appears to have originated from an authorized IP address.

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ3

CCSE Update

In SPLAT, the command for setting the timeout was idle. To accomplish this and increase the timeout in Gaia, which command do you use?

Explanation

Gaia Clish configures the inactivity timeout with set inactivity-timeout <Timeout>. The timeout is specified in minutes for the Gaia command-line shell.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ4

CCSE Update

You are investigating issues with two gateway cluster members that cannot establish the first initial cluster synchronization. Which service does the FWD daemon use to perform a Full Synchronization?

Explanation

ClusterXL Full Sync transfers Security Gateway kernel-table information when a member initially joins or resynchronizes with a cluster. The fwd daemon performs this operation through an encrypted TCP connection on port 256; UDP port 8116 is for Delta Sync.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!

QuestionQ5

CCSE Update

You observed that CPU cores on the Security Gateway are typically 100% utilized and that many packets are being dropped. You do not currently have a budget for a hardware upgrade. To optimize the drops, you decide to use Priority Queues and fully enable Dynamic Dispatcher. How can you enable them?

Explanation

Check Point MultiQueue mode 9 enables both Dynamic Dispatcher and Priority Queues together, distributing traffic more effectively across available processing resources and helping reduce packet drops caused by saturated CPU cores.

Community Discussion

No comments yet. Be the first to start the discussion!

That's the end of the preview

It's free

100% of the questions are free for all users.
No strings attached.

Sign up freeLog in
Topics covered
CCSE Update
Know a question that should be here? Contribute to this exam
Back home