QuestionQ104

VerifiedTroubleshoot Business Continuity & Disaster Recovery (BCDR) Failures

An administrator sets up disaster recovery between an on-premises AZ and a Nutanix Cloud AZ. The deployment follows the documented workflow, and no configuration errors are reported during setup.

After enabling DR and assigning protection policies to several VMs with volume groups, the administrator initiates failover and finds that the VMs do not have their volume groups attached.

To troubleshoot, the administrator performs these verification steps:

  • The clusters are successfully paired in Prism Central.
  • Protection policies and replication schedules are configured correctly.
  • Recovery plan validation completes successfully.
  • The required firewall ports between sites are confirmed open.
  • Management IP addresses are reachable in both directions.

Despite this, the administrator observes that the volume groups are still not attached.

Which network-related prerequisite is most likely misconfigured?

Explanation

For a supported volume-group recovery, the recovery cluster’s Data Services IP (DSIP) provides access to the iSCSI targets. Management IP reachability and successful recovery-plan validation do not establish that the DSIP is configured and reachable. (dell.com)

There is an important limitation: the Nutanix DR 7.3 guide states that volume groups are not supported in Nutanix Cloud AZ DRaaS. The deployed version’s support must therefore be verified; configuring a DSIP alone may not resolve the stated scenario. (scribd.com)

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!