JN0-533: Juniper Networks Certified Specialist FWV (JNCIS-FWV)Demo

By Juniper · Question Mode

QuestionQ80

Platform Operations and Services

Exhibit

SSH V2 is active:

ns5gt-> get int et1  
Interface ethernet1:  
description ethernet1  
number 2, if_info 176, if_index 0, mode nat  
link up, phy-link up/full-duplex  
status change:1, last change:02/06/1997 18:02:32  
vsys Root, zone Trust, vr trust-vr  
dhcp client disabled  
  
PPPoE disabled  
admin mtu 0, operating mtu 1500, default mtu 1500  
*ip 192.168.1.1/24  
*manage ip 192.168.1.1,  
route-deny disable  
pmtu-v4 disabled  
ping enabled, telnet enabled, SSH enabled, SNMP enabled  
web enabled, ident-reset disabled, SSL enabled  
  
SSH is enabled  
SSH is ready for connections  
Maximum sessions: 3  
Active sessions: 3

You are the administrator of a NetScreen 5GT. The system administrator is unable to use SSH to log in to the NetScreen 5GT. Based on the exhibit, what is the issue?

  • A Interface eth1 does not permit logins using SSH.
  • B SSH is not enabled on the NetScreen 5GT.
  • C Interface eth1's link status is down.
  • D The maximum SSH session has been used.
Explanation

SSH access is enabled on ethernet1, the interface link is up, and the SSH service is ready. All three permitted SSH sessions are already active, so another SSH login cannot be accepted until an existing session ends.

Community Discussion

No comments yet. Be the first to start the discussion!