QuestionQ43

VerifiedBuild an IP network with interconnection and interworking

Which commands can be used to enable OSPF on R1’s loopback interface, 10.0.1.1/32?

Choose four
Explanation

An OSPF network statement enables OSPF on interfaces whose primary IP addresses match its address and wildcard-mask pair. A wildcard-mask bit of 1 is a “don’t care” bit. Each listed pair matches 10.0.1.1: the first ignores all bits, the second matches the first two octets, the third matches all bits exactly, and the fourth matches the first three octets. Cisco IOS IP Routing: OSPF Command Reference

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!