QuestionQ35

VerifiedEthernet switching network construction

On the network shown, an administrator creates an Eth-Trunk between SW1 and SW2 to increase link bandwidth and allow terminals in VLAN 10 and VLAN 20 to communicate. While the network is running, problems occur. Match each problem to its troubleshooting method.

Question Image

Drag & Drop
GE1/0/3 added to the Eth-Trunk is always in Down state.
The traffic sent from PC1 cannot reach PC3 after passing through the Eth-Trunk.
The Eth-Trunk cannot be established between the two devices.
Explanation

A Down Eth-Trunk member is diagnosed by inspecting its physical-interface status and error counters. VLAN traffic can cross the Eth-Trunk only when the VLANs permitted on the trunk are consistent at both ends. Eth-Trunk formation also requires the aggregation modes configured on the two devices to match.

Community Discussion

No comments yet. Be the first to start the discussion!