QuestionQ54

VerifiedAnalyze

A customer has an HPE Aruba Networking ClearPass cluster. The customer uses AOS-CX switches that perform 802.1X authentication through HPE Aruba Networking ClearPass Policy Manager (CPPM). The switches use local port-access policies.

The customer wants to begin tunneling wired clients that pass user authentication only to an HPE Aruba Networking gateway cluster. The gateway cluster must place these clients in the eth-internet role. The gateway must also assign the clients to VLAN 20.

The proposed enforcement policy and profiles are shown below:

Question Image

Question Image

The gateway cluster contains two gateways with the following IP addresses:

  • Gateway 1
    • VLAN 4085 (system IP) = 10.20.4.21
    • VLAN 20 (users) = 10.20.20.1
    • VLAN 4094 (WAN) = 198.51.100.14
  • Gateway 2
    • VLAN 4085 (system IP) = 10.20.4.22
    • VLAN 20 (users) = 10.20.20.2
    • VLAN 4094 (WAN) = 198.51.100.12
  • VRRP on VLAN 20 = 10.20.20.254

The customer needs high availability for tunnels between the switches and the gateway cluster. If one gateway fails, the other gateway must take over its tunnels. The switch must also be able to discover the gateway cluster whether either gateway is present in the cluster.

Refer to the scenario.

You are configuring the UBT zone on an AOS-CX switch. Which IP addresses should you configure in the zone?

Explanation

A UBT zone uses a gateway/controller system IP for its primary controller. In a single gateway cluster, configure only one cluster member’s system IP; configuring both the primary and backup controller addresses from the same cluster is unsupported. The gateway cluster provides discovery of its members and tunnel failover, so gateway 1’s system IP, 10.20.4.21, is configured as the primary controller with no backup controller.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!