QuestionQ44

VerifiedAnalyze

A customer operates an HPE Aruba Networking ClearPass cluster. The customer has AOS-CX switches that use 802.1X authentication with HPE Aruba Networking ClearPass Policy Manager (CPPM).

The switches use local port-access policies. The customer wants to begin tunneling only wired clients that successfully pass user authentication to an HPE Aruba Networking gateway cluster. The gateway cluster must place these clients in the eth-internet role. The gateway must also assign clients to VLAN 20.

The planned enforcement policy and profiles are shown below:

Question Image

Question Image

The gateway cluster includes two gateways with the following IP addresses:

  • Gateway 1
    • VLAN 4085 (system IP) = 10.20.4.21
    • VLAN 20 (users) = 10.20.20.1
    • VLAN 4094 (WAN) = 198.51.100.14
  • Gateway 2
    • VLAN 4085 (system IP) = 10.20.4.22
    • VLAN 20 (users) = 10.20.20.2
    • VLAN 4094 (WAN) = 198.51.100.12
  • VRRP on VLAN 20 = 10.20.20.254

The customer requires high availability for tunnels between the switches and the gateway cluster. If either gateway fails, the other gateway must take over its tunnels. The switch must also be able to discover the gateway cluster even if one gateway in the cluster is unavailable.

Refer to the scenario.

Assume the correct UBT zone and port-access role settings have been configured. However, the solution does not work.

What else must you ensure you do?

Explanation

When UBT uses local/reserved-VLAN mode, the gateway assigns the client VLAN and policy, while the AOS-CX switch requires a dedicated, configured UBT client VLAN as the reserved transport VLAN for tunneled clients. VLAN 20 is assigned at the gateway, so it is not configured as the edge-port access VLAN for this design.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!