Building HPE Data Center Solutions (HPE0-S51)Demo

By HP · Question Mode

QuestionQ9

Validate, install, configure, and upgrade HPE SMB solutions and their components

You are upgrading firmware on two SN6000 switches in a fabric through a CLI connection. You did not wait for the upgrade on the first switch to activate before starting to install firmware on the second switch.

What must you do to install the firmware on the second switch?

  • A Perform a hot reset on the first switch to initiate the installation on the second switch
  • B Reactivate the upgrade on the first switch before attempting to update the firmware on the second switch
  • C Reinitialize the devices attached to the first switch before installing the firmware on the second switch
  • D Perform a hot reset on the second switch after the first switch is activated
Explanation

When firmware activation on a second switch is started before activation completes on the first switch in the fabric, the second switch's installation is completed by performing a hot reset later, after the first switch has activated its upgrade. This is the recovery procedure specified in the HPE SN6000 CLI documentation.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!