QuestionQ28Verified/VxRail Deployment PlanningCopy linkReport a problemAsk AstroTutorSave questionWhich two requirements are needed for automatic node discovery?Choose twoAThe switches must be configured to allow IPv6 multicast traffic.BThe internal management VLAN must be configured on the switches for the nodes.CThe switches must be configured to allow IPv4 multicast traffic.DThe management IP addresses must be set on the nodes.Show AnswerAnswerExplanationVxRail automatic node discovery depends on a configured internal management VLAN and IPv4 multicast connectivity on that network. Dell’s VxRail Network Planning Guide specifies configuring the Internal Management VLAN on the switches and allowing multicast on the Internal Management network to support device discovery.Learn moreDell VxRail Network Planning Guide — Configure VLANs for the VxRail networksShow comments0Show commentsCommunity DiscussionNo comments yet. Be the first to start the discussion!
Community Discussion