QuestionQ37

VerifiedDeployment

During the boot process, which two steps are required to configure the iDRAC on a Dell PowerProtect DD9910 system?

Choose two
Explanation

Per Dell's official DD9410/DD9910 System Installation and Storage Expansion Guide, configuring iDRAC requires first connecting to the system's serial console (or KVM) and rebooting the system so that the BIOS/iDRAC settings menu can be accessed by pressing F2 during boot. From there, the administrator navigates to iDRAC Settings > Network and configures a static IP address for iDRAC — the guide explicitly notes that DHCP is not supported for the iDRAC IP address on this appliance. NTP configuration is unrelated to this iDRAC network setup procedure.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!