350-101: Implementing and Operating Cisco Wireless Core TechnologiesDemo

Question

A business needs a Cisco 9163E AP to serve as a point-to-point connection between two campus buildings. No wired connection exists between the sites, and the AP must relay network traffic over the wireless link. The administrator must ensure the AP is configured to forward Ethernet frames between its radio and Ethernet interfaces.

Which CLI command must the administrator use to configure the AP for this application?

A ap name campus mode flexconnect
B ap name campus capwap mode p2p
C ap name campus mode bridge
D ap name campus capwap mode mesh

Explanation

Bridge mode enables an AP to form a point-to-point wireless bridge that carries Layer 2 Ethernet traffic between locations. On Cisco Catalyst 9800 Wireless Controllers, the command to configure an AP for bridge mode is ap name <ap-name> mode bridge; with the AP name campus, this is ap name campus mode bridge.

Learn more

Cisco Catalyst 9800 Series Wireless Controller Command Reference — ap name mode bridge

350-101: Implementing and Operating Cisco Wireless Core TechnologiesDemo

AstroTutor

Notes

Readiness

QuestionQ43

Community Discussion