QuestionQ96

VerifiedLayer 3 VPNs

Question Image

Refer to the exhibit. Edge router R1 is deployed at a Tier 1 ISP and uses OSPF with TE extensions in area 0 as the underlay routing protocol. The tunnel is configured with explicit path-option path1 and bandwidth 300. A network engineer recently replaced a failed PSU module on R1 and reloaded the router. The engineer then configured mpls traffic-eng tunnel path-option protect for one of the customer’s MPLS LSPs. After this configuration, the LSP went down with the error message LSP-ERROR-Indication: Path Setup Failed. Which action must the engineer take to resolve the issue?

Explanation

MPLS Traffic Engineering must be enabled in the OSPF process for area 0 so that OSPF floods TE information and the router can calculate and signal the RSVP-TE LSP path. The required OSPF router-configuration command is mpls traffic-eng area 0.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!