QuestionQ71

VerifiedLayer 3 VPNs

Question Image

Refer to the exhibit. A network engineer is configuring MLDP on router PE1, as shown, to support multicast-packet routing and forwarding for multiple VRFs. The network design requires every PE router to join the MP2MP tree and receive traffic on MP2MP trees. Which additional command sequence must the engineer configure on PE1 to complete the configuration?

Explanation

An MLDP-based MVPN uses a default MDT over an MP2MP tree. The VRF must prefer MLDP and configure a default MLDP MDT root with mdt default mpls mldp 192.168.20.1; the data-MDT pool and traffic threshold provide the corresponding data-tree configuration. The VPN ID and route targets already present identify the VPN and allow MLDP to derive the relevant FEC. Cisco documents mdt preference mldp, mdt default mpls mldp, mdt data mpls mldp, and mdt data threshold as the MLDP-based MVPN VRF configuration sequence.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!