QuestionQ64

VerifiedLayer 2 VPNs

Question Image

Refer to the exhibit. A Cisco engineer at a service provider must deploy single-homed EVPN-VPWS. When PE1 receives an EVPN per-EVI EAD route from PE2, it must install the entry in its local Layer 2 RIB. The engineer has started the deployment by applying this configuration on PE1. Which additional configuration must be applied to PE1 to complete the EVPN-VPWS deployment?

Explanation

Single-homed EVPN-VPWS uses an L2VPN point-to-point cross-connect that associates the local attachment circuit with an EVPN peer through the EVI and source/target attachment-circuit IDs. The required PE1 configuration is xconnect group, p2p, the local interface, and neighbor evpn evi 100 target 12 source 10. Ethernet-segment configuration is used for EVPN multihoming rather than this single-homed service. Cisco’s EVPN-VPWS single-homed example uses this same cross-connect and neighbor evpn evi structure.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!