QuestionQ65

VerifiedAdvanced Troubleshooting Techniques

Some users in your organization have reported CIFS connection problems since this morning. You suspect an IPS issue following an automatic IPS update last night. You want to perform a packet capture on uppercase I only, directly after the IPS module (position 4 in the chain), to verify whether packets pass through IPS. Which command do you need to run?

Explanation

In Check Point fw monitor, -mI selects the uppercase I inspection point, and -pI <Position> inserts the monitor at a post-inbound chain position. Position 5 places the capture immediately after the IPS module at position 4. The lowercase -pi parameter instead specifies a pre-inbound position.

Learn more

Community Discussion

No comments yet. Be the first to start the discussion!